Tascam TM-2X Stereo XY Condenser DSLR Microphone
UPC043774030392
SKUTM-2X
CA$139.00
Online financing options available at checkout
Receive 695 points!Get a 10% discount by reaching 25,000 points
1
Available Online
Usually 1-2 weeks before shipment
Not In-Store
In case of additional delays, you will be contacted by one of our sales representative.
Any questions? We are here to help.
Description
The TM-2X Stereo XY Condenser DSLR Microphone from Tascam is designed to record stereo audio directly to your DSLR camera's microphone input. It can be mounted directly on your camera's hot shoe mount and is capable of being swiveled 180-degrees. The TM-2X has two switchable sensitivities, allowing it to work with a range of cameras. As it is powered by plug-in power from your camera, it requires no external batteries for operation.
A low-cut filter at 130Hz allows you to eliminate low-frequency rumble while the included noise isolation arm helps prevent the mic from picking up mechanical noise from your DSLR. For outdoor filming, a fur windscreen is included to help reduce wind noise. The TM-2X can handle SPL up to 120dB, allowing it to be used on a variety of sources.
-
- Can be mounted directly to the camera accessory shoe and swiveled by 180 degrees to capture sound sources in front or behind the user
- Tripod attachment screw-hole (1/4-inch) allows for optional tripod to place the microphone apart from the camera
- XY orientation for stereo definition and minimal phase differences
- Accepts sound pressure levels up to 125 dB SPL
- Switchable input sensitivity for functionality with most camera models
- Switchable low-cut filter to minimize unwanted low-frequency noise
- Operates with plug-in power from your camera - no battery required
- Included noise isolation arm reduces possible noise being recorded from the camera's lens or stabilizer mechanisms
- Included fur windscreen reduces wind and environmental noise
Type Condenser Polar Pattern Cardioid Frequency Response 50 Hz to 20 kHz Maximum Input Level 120 dB SPL (@ 1 kHz with sensitivity set to H and low-cut filter set to FLAT) Output Impedance 1.6 kΩ (RL = 2.2 kΩ, Vcc = 2.5 V ) Signal to Noise Ratio 74 dB typical (RL = 2.2 kΩ, Vcc = 2.5 V ) Sensitivity H Setting: −37 dB (1 kHz, 0 dB = 1 V/Pa), (RL = 2.2 kΩ, Vcc = 2.5 V )
L Setting: −52 dB (1 kHz, 0 dB = 1 V/Pa), (RL = 2.2 kΩ, Vcc = 2.5 V )Low Cut Filters 130 Hz (RL = 2.2 kΩ, Vcc = 2.5 V ) Cable Length 13" (33 cm) Connector 1/8" (3.5 mm) TRS stereo mini plug (Tip: left channel, Ring: right channel, Sleeve: ground) Power Requirement Plug-in power (JEITA standard CP-1203A) Operating Temperature Range 41 to 95°F (5 to 35°C) Dimensions (WxHxD) 2.2 x 2.3 x 2.7" (57 x 59 x 69 mm), excluding cable and accessories) Weight 2.6 oz (75.0 g)
Estimated shipping calculator
Estimated shipping calculator
Warranty
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. This warranty is only valid within the United States when product is purchased within the United States.
WHAT IS COVERED AND WHAT IS NOT COVERED
Except as specified below, this warranty covers all defects in material and workmanship in the product. The following are not covered by the warranty:
1.Damage to or deterioration of the external cabinet or surface.
2.Damage resulting from accident, misuse, abuse, or neglect.
3.Damage resulting from failure to perform basic daily maintenance and/or calibration, or otherwise resulting from failure to follow instructions contained in the product owner's manual.
4.Damage occurring during shipment of the product (claims must be presented to the carrier).
5. The use of non-TEAC parts and services, unauthorized service technicians and do-it-yourself repairs are not eligible for warranty reimbursement.
6.Damage resulting from causes other than product defects, including lack of technical skill, competence, or experience of the user.
7.Damage to any unit which has been altered or on which the serial number has been defaced, modified, or removed.
8. Warning: For TEAC products that are FDA and/or FAA certified the use of non-TEAC parts, unauthorized service technicians and do-it-yourself repairs could de-certify the unit.
9. Products not purchased from an authorized TASCAM dealer in the United States.
WHO MAY ENFORCE THE WARRANTY
This warranty may be enforced only by the original purchaser.
LENGTH OF WARRANTY
One (1) year including parts and labor from the date of original purchase.
WHAT WE WILL PAY FOR
We will pay all labor and material expenses for items covered by the warranty. Payment of shipping charges is discussed in the next section of this warranty.
HOW YOU CAN GET WARRANTY SERVICE
Your unit must be serviced by an authorized TASCAM service station in the United States. (This warranty is not enforceable outside the U.S.) If you are unable to locate an authorized TASCAM service station in your area, please contact us. We either will refer you to an authorized service station or instruct you to return the unit to the factory. Whenever warranty service is required, you must present both the original dated sales receipt and this warranty statement as proof of warranty coverage.
You must pay any shipping charges if it is necessary to ship the product for service. However, if the necessary repairs are covered by the warranty, we will pay return surface shipping charges to any destination within the United States.
LIMITATION OF IMPLIED WARRANTIES
Any implied warranties, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, are limited in duration to the length of this warranty.
EXCLUSION OF DAMAGES
TEAC's liability for any defective product is limited to repair or replacement of the product, at TEAC's option. TEAC shall not be liable for:
1.Damages based upon inconvenience, loss of use of the product, loss of time, interrupted operation or commercial loss; or
2.Any other damages, whether incidental, consequential or otherwise.
Some states do not allow limitations on how long an implied warranty lasts and/or do not allow the exclusion or limitations of incidental or consequential damages, so the above limitations and exclusions may not apply to you.
WHAT IS COVERED AND WHAT IS NOT COVERED
Except as specified below, this warranty covers all defects in material and workmanship in the product. The following are not covered by the warranty:
1.Damage to or deterioration of the external cabinet or surface.
2.Damage resulting from accident, misuse, abuse, or neglect.
3.Damage resulting from failure to perform basic daily maintenance and/or calibration, or otherwise resulting from failure to follow instructions contained in the product owner's manual.
4.Damage occurring during shipment of the product (claims must be presented to the carrier).
5. The use of non-TEAC parts and services, unauthorized service technicians and do-it-yourself repairs are not eligible for warranty reimbursement.
6.Damage resulting from causes other than product defects, including lack of technical skill, competence, or experience of the user.
7.Damage to any unit which has been altered or on which the serial number has been defaced, modified, or removed.
8. Warning: For TEAC products that are FDA and/or FAA certified the use of non-TEAC parts, unauthorized service technicians and do-it-yourself repairs could de-certify the unit.
9. Products not purchased from an authorized TASCAM dealer in the United States.
WHO MAY ENFORCE THE WARRANTY
This warranty may be enforced only by the original purchaser.
LENGTH OF WARRANTY
One (1) year including parts and labor from the date of original purchase.
WHAT WE WILL PAY FOR
We will pay all labor and material expenses for items covered by the warranty. Payment of shipping charges is discussed in the next section of this warranty.
HOW YOU CAN GET WARRANTY SERVICE
Your unit must be serviced by an authorized TASCAM service station in the United States. (This warranty is not enforceable outside the U.S.) If you are unable to locate an authorized TASCAM service station in your area, please contact us. We either will refer you to an authorized service station or instruct you to return the unit to the factory. Whenever warranty service is required, you must present both the original dated sales receipt and this warranty statement as proof of warranty coverage.
You must pay any shipping charges if it is necessary to ship the product for service. However, if the necessary repairs are covered by the warranty, we will pay return surface shipping charges to any destination within the United States.
LIMITATION OF IMPLIED WARRANTIES
Any implied warranties, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, are limited in duration to the length of this warranty.
EXCLUSION OF DAMAGES
TEAC's liability for any defective product is limited to repair or replacement of the product, at TEAC's option. TEAC shall not be liable for:
1.Damages based upon inconvenience, loss of use of the product, loss of time, interrupted operation or commercial loss; or
2.Any other damages, whether incidental, consequential or otherwise.
Some states do not allow limitations on how long an implied warranty lasts and/or do not allow the exclusion or limitations of incidental or consequential damages, so the above limitations and exclusions may not apply to you.
Tascam TM-2X Stereo XY Condenser DSLR Microphone
UPC043774030392
SKUTM-2X
CA$139.00
Online financing options available at checkout
Receive 695 points!Get a 10% discount by reaching 25,000 points
1
Available Online
Usually 1-2 weeks before shipment
Not In-Store
In case of additional delays, you will be contacted by one of our sales representative.
Any questions? We are here to help.