Value engineered car amplifier with JBL power and performance
The Club A5055 5-channel amplifier delivers a powerful 50-Watts RMS to each of the front and rear speakers in your car, and a pounding 500-Watts RMS to the subwoofer channel — a much smarter ratio of subwoofer-to-full-range power than what is typical in 5-channel amps. You can also bridge the amp to 3-channel mode to deliver 140-Watts RMS to your front speakers while driving your sub with 500-Watts RMS. Speaker-level inputs allow this amplifier to integrate into almost any system, even one using your car's factory radio. Separate high-pass and low-pass crossovers on the front and rear channels allow you dial in the perfect roll off to best suit speaker placement and cabin acoustics. The subwoofer channel features a low-pass crossover, selectable bass boost, and phase switch to optimize subwoofer performance.
Specifications
- 5 channel car amplifier
- 50 watts RMS x 4 + 320 watts RMS x 1 at 4 ohms
- 65 watts RMS x 4 + 500 watts RMS x 1 at 2 ohms
- 140 watts RMS x 2 bridged at 4 ohms + 500 watts RMS x 1 at 2 ohms
- variable high- and low-pass filters (32-320 Hz, 12 dB/octave) on front and rear channels
- low-pass filter (32-320 Hz, 12 dB/octave) on subwoofer channel
- bass boost on subwoofer channel (0-12dB at 45Hz)
- phase switch on subwoofer channel (0, 180 degrees)
- preamp and speaker-level inputs
- fuse rating: 30A x 3
- 4-gauge power and ground leads recommended — wiring and hardware not included with amplifier
- WxHxD=360mm x 51.3mm x 180mm (WxHxD=14-3/16” x 2-1/16" x7-1/8”)
What's in The Box?
- 1 x Club A5055 five channel amplifier
- 4 x Bare wire-to-RCA adapters
- 6 x 30A ATO fuses (3 installed, 3 spare)
- 1 x Remote bass control module
- 1 x 16.5' Remote control cable (RJ-25 plugs on both ends)
- 2 x Self-tapping screws for remote (M3 x 15mm)
- 4 x Mounting screws (M4 x 53mm)
- 1 x Owner's manual
