The AN-16/i v.2 Input Module is used to connect up to 16 balanced line-level inputs from a mixing console’s direct outputs, insert points, aux sends, and/or submixes to a personal mixing system. When used alone, one AN-16/i v.2 can generate a single 16-channel A-Net signal.
The A-Net In on the AN-16/i v.2 allows multiple Pro16 input devices (including console cards, AN-16/i-M, and the original AN-16/i) to be connected together to generate the higher channel count Pro16e™ version of A-Net used by the A360 Personal Mixer and A320 Personal Mixer.
Compatibility Note: The Pro16e A-Net output of the AN-16/i v.2 is not compatible with the original A-16 Personal Mixer, AV-P2 Output Module, AN-16/o v.3 Output Module, and AN-16/o v.4 Output Modules with serial numbers 51162 and lower.
Features
- Sixteen balanced audio inputs (1/4-in TRS connectors)
- Sixteen balanced Thru connectors (TRS)
- A-Net In with four-position slot range selector switch
- Stereo Link switches for each channel pair
- Four-position gain switches (+22, +4, 0, -10dB)
- Signal present and clip LEDs per channel
Specifications
| Audio Inputs |
16, balanced line-level, 1/4-inch TRS connector |
| Inputs |
Tip: Audio +; Ring: Audio -; Sleeve: Ground |
| TRS Thru |
Impedance matched output |
| Analog to Digital Conversion |
48kHz sample rate, 24 bit |
| Frequency Response |
4Hz-22kHz |
| A- Net In |
One Category 5 (RJ45 connector)
Four-position slot range selector switch for use with Pro16e A-Net |
| A-Net Out |
One Category 5 (RJ45 connector) |
| Gain Settings |
Four-position switch, -10dBv, 0dBu, +4dBu, and +22dBu |
| Channel LED Indicators |
Signal Present and Clip, per channel |
| Line Inputs |
Impedance: 48k ohms |
| Metering |
LEDs; green: Signal Present, red: Clip; per channel |
| Stereo Operation |
Stereo Link, per channel pair;
Two-position switch (Normal, Link) |
| Maximum Input Level |
+22dBu |
| Input Impedance |
17.8k ohm |
| Freq. Response |
4Hz-22kHz +0.2dB/-3dB |
| THD +N |
< 0.003% |
| Crosstalk |
-90dB |
| Bit Error Rate (BER) |
10(-12) |
| Signal to Noise (unweighted) |
90dB typical, A/D to D/A
Measured from AN-16/i to AN-16/o Output Module |
| Digital Outputs |
A-Net: 1; RJ45 connector |
| Pro16e A-Net |
Use unshielded Cat-5e UTP (or better) cable |
| Latency |
<0.880 msec (measured from analog input to analog output) |
Power Supply
Input Voltage
Output Voltage
Plug Size |
External, DC, universal switching type
100-240 volts, 50/60Hz, 30VA
18-24 VDC, 0.5 amp
2 mm |
| Power |
18-24 VDC, 500mA |
| Dimensions |
19" (482.6 mm) wide x 5.75" (146 mm) deep;
1U high |
| Weight |
6.8 lb (3.08 kg) |
