The Radial Engineering PowerPre Microphone Preamplifier is designed to be used with the Radial Workhorse and other 500 series modular racks. It features 100% discrete components for optimal signal transfer and employs a vintage Hammond broadcast output transformer for warmth and a smooth tone.
The design begins with a front-mounted XLR for instant connectivity plus a recessed 48V phantom power switch for safety. Unlike most microphone preamps that require careful gain adjustment to avoid troublesome noise, the PowerPre Microphone Preamplifier is equipped with the AccuState input stage that automatically optimizes signal-to-noise at all levels with up to 55 dB of gain. This is supported with a full 10-segment LED meter for precise signal monitoring.
To add extra character, a 3-position Vox control lets you set the PowerPre Microphone Preamplifier to breath for added high-frequency air such as while accentuating a vocal track or adding harmonic content to an acoustic guitar. The punch setting adds body while recording electric guitar or can be used to fatten a voice. When set to linear, the PowerPre Microphone Preamplifier delivers a truly natural rendering for orchestral recording that suits demanding purists. This is augmented with a gentle, high-pass filter that helps control low-end resonance while layering acoustic instruments.
10-Segment LED
-15 dB Pad
180° Polarity Reverse
Filter
Output
Vox
48V
Mic Input
XLR Output
Omniport
Full Enclosure
100% Discrete Electronics
Radial Push Switches
Double-Layer Front Panel
Dual Potentiometer
Heavy-Duty XLR
Mini Slider Switch
Hammond Transformer
Gold-Plated 15-Pin Card Edge
Mil-Spec Circuit Board
Gold-Sealed Relay
Applications
The PowerPre Microphone Preamplifier fits any 500 series rack. In its most basic setup, you connect a microphone to the PowerPre Microphone Preamplifier and send the XLR out to the recording system. Single dial control makes recording easy and efficient.
The Microphone Channel
Use the PowerPre Microphone Preamplifier as the front end to drive an EQ and compressor to create a functional channel strip. Simply cascade one module into the next and send the final output to your recorder.
Tracking Instruments
The PowerPre Microphone Preamplifier is not just for microphones. If you have a Workhorse, you can also use it as the front end while recording instruments or tracking a bass direct. Simply plug into the Omniport and you are set to go.